Microlinks UM05 - user manual Manuel d'utilisateur télécharger pdf (Page 61)

Microscope Application Program http://www.ViTiny.com

Fig. 5-60 Input the actual measurement length

The calibration frame can be freezed by pressing the right button on the

mouse. The freezed frame helps for calibrating in a stable condition. Put the

calibrator under the machine and adjust focus to clearly see the scale. Key in “400”

length in the check-box of “Input Measurement Length”. Use mouse to draw a

yellow line for 4.00mm.Click “Finished” to complete and save the new calibration

figure.

The new setting scale (Calibration Scale [New]) show on the frame. See

Fig.5-61.

Fig. 5-61 Draw a line in actual length

5.4.6Scale information setting “ ”

This setup screen indicates to set whether to show the unit value or not, see Fig. 5-60.

Choose “length” means to display the length of the line, by capital letter “L” expression, if

length is 2.33mm, it will show L=2.33mm besides the line. If choose “none”, no value will

show on the dialogue. If show “P” means “perimeter”, “A” means “Area”, “C” means

“Circumference, and “R” means ”radius”

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 71 72

Pas de commentaire

Microlinks UM05 - user manual Manuel d'utilisateur Page 61