Microlinks UM12 - user manual Manuel d'utilisateur télécharger pdf (Page 72)

Microscope Software manual http://www.ViTiny.com

5.5.4 Focus and Calibration

(1) Manual focus ： Manually operate zoom in/out to complete focus. Refer to

“5.7.7”, fast key “4”.

(2) Single autofocus ：Only focus one time even if image is blurry because of

moving the object or changing distance. Fast key “5”.

(3) Continuous autofocus: ：Re-focus when the image is blurry, stop until image

is clear. Fast key “6”

(4) Calibration of whole operation ：Re-calculating the whole operation steps.

After using for some period or electricity black out occur, please calibrate the

whole operation when re-connect the power. Fast key “7”.

(5) Calibration of initial position ：Return to high magnification (original position),

if the electricity black out occur, please calibrate the original position. Fast key

“8”.

Fig 5-83 Focus ways and motor calibrate menu

5.5.5 Focus area

In Manual focus mode, based on the distance from lens to object or FOV to choose the

focus area/section. There are 15 sections options. (refer to Fig 5-84) Choose one section

(ex:1.95cm, FOV 2.34mm) then adjust the microscope height as to 1.95cm, tuning the

stand height to find the clear image, and the magnification size will show on the screen

corner.

In autofocus mode, choose the height from 15 sections if already know the distance

from lens to object, and it will only focus in the chosen section.

(1) 15 focus sections: the blue/red

rectangle is to show the current lens height.

(2) Whole area : search focus in whole area. (only for Autofocus mode)

1 2 ... 67 68 69 70 71 72 73 74

Pas de commentaire

Microlinks UM12 - user manual Manuel d'utilisateur Page 72